D
Deleted member 706
Guest
Given the 1" to 7/8" design of the bars on my base model FTR what are my options for bigger handle bars?
As far as I can tell they are quite limited.
As far as I can tell they are quite limited.
They are 1 1/8” to 7/8” actually, a fairly common size for motorcycles (like ALL enduro and mx bikes).Given the 1" to 7/8" design of the bars on my base model FTR what are my options for bigger handle bars?
As far as I can tell they are quite limited.
Well thanks for the suggestion, not only do they look pretty good the price is reasonable. I'd hope that they will be a simple bolt on swap over too, no stuffing around with wiring or hydraulic hoses...oh you mean higher?
yeah lots of options there. also look at the Indian Rally Bars.
The genuine Rally bars were sold out when I set mine up so I went for Pro-Taper Adventure high, they are probably as high as you'd want to go without altering cables.Well thanks for the suggestion, not only do they look pretty good the price is reasonable. I'd hope that they will be a simple bolt on swap over too, no stuffing around with wiring or hydraulic hoses...
I know this thread is about higher bars (and although it made sense not to start another thread, I didn't mean to hijack it), but that's precisely the opposite of what I'm looking to replace the standard bars with. Like I said, I want something with less raise - a flatter bar. I need to know the specification of the OEM bars, specifically, the height and raise.O think you’ll like them. I put mine on this week. Indian has instructions on what it takes. One of our kind brethren hooked me up with them. Im tall and wanted a better ridin position View attachment 5869
I know this thread is about higher bars (and although it made sense not to start another thread, I didn't mean to hijack it), but that's precisely the opposite of what I'm looking to replace the standard bars with. Like I said, I want something with less raise - a flatter bar. I need to know the specification of the OEM bars, specifically, the height and raise.
Thanks for that. In terms of raise, as I explained I have always found the precise points for measurement ambiguous - I have read several different guidelines. Simply wondered whether anyone knew the specifications of the OEM bars - or indeed what they actually are meaning I could then establish that myself.I'm confused, do you not have standard bars? If you do, just measure them???